NM Engineering Power Module NM.648856

A power module that can be easily installed via plug and play to increase the output of the MINI Cooper S N18 engine by 30-40 PS.

The NM Engineering Power Module is a device newly designed and developed by NM Engineering R&D for the N18 engine to improve engine power output. It increases boost pressure by 0.28 to 0.35 bar by changing the charge pressure reading without changing the DME program. Boost pressure control increases in a gentle progressive manner, maintaining natural torque characteristics without discomfort and increasing engine torque by approximately 40-50 Nm across the entire range. In addition, engine power can be increased by up to 40 PS. Boost pressure, ignition timing, and air-fuel ratio corrections are adjusted to appropriate values ​​using feedback from the ECU's closed loop control, so installing the power module will not have any adverse effects on the engine or drive system.

[Characteristics of power modules and effects of installation]
○ The way you use your car will not change at all after installation.
○ After installation, no fault codes will be entered into the engine or drive system DME.
○ Even with the DME installed, you can receive DME service updates at an authorized dealer.
In addition, this unit will not be affected by DME service updates.
○ It will not be recorded in the logs of authorized dealers' diagnostic equipment, so it will not affect the manufacturer's new car warranty.
Does not affect idle or cruise control.
○ The measured value of the map sensor vacuum area when the throttle valve is fully closed is the original value.

[Precautions when installing the power module]
○ The power module is designed specifically for each engine model, so it cannot be used with engines other than those for which it is compatible.
○ Cannot be used on vehicles that have ECU tuning programs from other manufacturers installed.
○ Cannot be used in conjunction with modules or throttle controllers from other manufacturers.
○ Please use the genuine air intake or NM Engineering high flow intake kit.

[Product Warranty]
The product warranty period for this product is one year from the date of purchase. The warranty is limited to installation on compatible vehicles and only malfunctions of this product are covered by the product warranty. Please note that any malfunctions or defects that occur in the engine, transmission, or other electrical systems after installation of this product are not covered by the warranty.